Roundover Bit HW R1‑OFK 500 Z1

The Festool Roundover Bit HW R1‑OFK 500 Z1 is designed for clean, controlled edge profiling on small and delicate workpieces using the OFKC 500 cordless edge router. Its single‑cutter design helps manage heat buildup during routing, producing smooth, consistent round‑over edges with minimal surface marking on both solid wood and plastic edge banding.

This bit mounts directly to the router spindle using Festool’s collet‑free hollow‑shaft system, eliminating collet runout and reducing setup time. The flush‑mounted ball bearing design keeps the installation height low, allowing routing in rabbets or across stacked panels where clearance is limited. A precision‑matched cutter radius and relief angle guide the cut cleanly along the edge for uniform results from start to finish.