Roundover 2 Cutter 3/32″ (2 mm)

The Festool 3/32″ Roundover Bit HW R2‑OFK 500 is built for controlled, accurate edge profiling on solid wood and plastic edge banding using the OFK 500 trim router. It cuts a smooth, consistent round‑over that cleans up sharp edges and leaves a uniform finished profile on small parts and detailed work.

A hollow, direct‑thread design mounts straight onto the router shaft without a collet, improving run‑out accuracy and reducing vibration at the cutter. This keeps the cutting radius consistent from start to finish and allows clean results even on narrow edges or stacked material.

Two carbide cutting edges extend service life while maintaining a steady cut. The precision‑ground radius transitions into a 5° relief angle, helping the bit exit the cut smoothly and reduce surface marking. A low‑profile design allows routing inside rabbets or across layered panels without sacrificing control.